Table saw is down, saw Stop went off.
3 Likes
New blade and brake getting installed tomorrow.
Still not sure what could have set it off. My hunch is wet lumber or even a static buildup. Hard to know without looking at the wood and the type of cut going on.
2 Likes
He said he was cutting a 4x4, so I’m assuming pine.
2 Likes
4x4… I hope it wasn’t treated. And if it was, it was probably wet
1 Like
It wasn’t
···
On Wed, Apr 16, 2025, 8:34 PM Dave Hanson via MakeICT Forum <noreply@talk.makeict.org> wrote:
| whateg01 MakeICT Member
April 17 |
- | - |
4x4… I hope it wasn’t treated. And if it was, it was probably wet
Visit Topic or reply to this email to respond.
To unsubscribe from these emails, click here.
1 Like
Any update on table saw?
1 Like
I am told that they saw stuff is still down. I will pick up a cartridge on Monday and try to get it installed Monday afternoon. I apologize for the delay
1 Like