hi, can I get approved to run millport or have someone mill a couple parts for me thanks curtis
I asked in the other thread what you needed done but you never said
sorry I missed that part. . I got a alum plate that i want flat to sand thing on so they will be flat. and clean up a set of alum head some body cleaned with a wire brush. NOT me. thanks curtis
How big are the parts? We don’t have a knee mill and the machine only has so much travel. Also, how flat is flat? I don’t know if the machine could hold 0.001" over 12".
16 x 20 inch for flat. I want it for bottom of Carbs, heades on small gas engine. an sand on some stuff I laser to clean it up. cyl head is 20x9" if we can’t do them can someone use the CNC mill the heads flat? Thanks curtis
16 x 20 inch for flat. I want it for bottom of Carbs, heades on small gas engine. an sand on some stuff I laser to clean it up. cyl head is 20x9" if we can’t do them can someone use the CNC mill the heads flat? Thanks curtis
···
On Wednesday, June 4, 2025 at 08:47:29 PM CDT, Dave Hanson via MakeICT Forum noreply@talk.makeict.org wrote:
| whateg01 MakeICT Member
June 5 |
- | - |
How big are the parts? We don’t have a knee mill and the machine only has so much travel. Also, how flat is flat? I don’t know if the machine could hold 0.001" over 12".
Visit Topic or reply to this email to respond.
To unsubscribe from these emails, click here.