I have a similar question - although about an artwork frame that was not right at 45 deg. We had a frame precut and sent to us (too many details to go into why we chose this route) for a piece of artwork a family member did in Maryland. When we took the frame to a local frame shop to mount the artwork they found the angles to be off (see attached
I understand frames usually use a special saw blade and even saw. Is it possible to recut this frame using the woodshop miter saw and 1) get an true 45 angle 2) not damage the finish on the frame?
The frame is about 3.5" wide and about 1.25" tall.
Any thoughts on how to recut this? Or should we just find a frame shop that could fix it?
Thanks for your advice!